Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V1.0
3.
Run the compressor at a low volume and check the connection for air
leaks. Do not use the tool until all air leaks are repaired or the faulty
component is replaced.
IMPORTANT! Vibration may cause failure if a quick coupler is connected directly
to the air tool. To overcome this, connect a leader hose to the tool. A quick
coupler may then be used to connect the leader hose to the air line hose.
BLADE INSTALLATION
CAUTION! The blades are sharp and may cut you if improperly handled.
Wear gloves to protect your hand during blade installation and removal.
1.
Disconnect the air scraper from the air hose and squeeze the trigger
lever (C) to release any residual air.
2.
Choose the blade that is appropriate for the task.
3.
Loosen both cap head screws (A) with a hex key. Remove the screws
by hand.
4.
Remove the current blade by sliding it out of the blade holder (#13). Be
careful of the sharp edge. Place it in the tool box.
5.
Hold the blade only by the flat surfaces. Insert the selected blade into
the blade holder's slot and align the blade bolt holes with the screw
holes. Make sure the bevel is facing upward (same facing as the screws).
6.
Insert a screw into a screw hole and hand-tighten. Repeat with the
second screw. You may need to shift the blade if the bolt holes aren't
properly aligned to allow the screw to enter the bottom half of the
blade holder. Tighten with the hex key.
7.
Reconnect the air hose and start the compressor.
8.
Test the air scraper without load to ensure the blade is secure. Point
the blade at an unoccupied spot in case the blade is ejected.
OPERATION
1.
Set-up the compressor and connect the air scraper to the air hose.
2.
Hold the tool near the surface.
3.
Squeeze the trigger lever (C) and the blade will begin to vibrate.
4.
Increase or decrease the blows-per-minute by adjusting the air flow
control (D). The buzzing sound will rise with increased air flow and
slow when the flow is restricted.
5.
Place the blade firmly at an angle between the surface and the
material you wish to remove. Slowly push forward so the blade glides
over the surface while separating the unwanted material.
Visit www.princessauto.com for more information
Air Scraper Tool Kit
8843633
9
Publicité
Table des Matières
