Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8843658
Problem(s)
Tool runs slowly.
Air flows slightly
from exhaust.
Tools will not run.
Air flows freely
from exhaust.
Tool will not shut
off.
Loss of power or
erratic
performance.
12
Straight Grip Air Shear
Possible Cause(s)
1. Air regulator in closed
position.
2. Damage or excessive
wearing of internal parts.
Damage or excessive
wearing of internal parts.
1. Throttle valve o-ring
dislodged from inlet
valve seat.
2. Trigger mechanism
jammed or dirty.
1. Excessive drain on the
air hose. Incorrect size or
type of hose connectors.
2. Moisture or restriction in
the air hose/tank
3. Air compressor has
insufficient flow.
Suggested Solution(s)
1. Open the air regulator to
desired airflow.
2a. Have a qualified technician
service the tool.
2b. Replace tool or parts.
1.
Have a qualified technician
service the tool.
2.
Replace tool or parts.
1. Replace throttle valve
o-rings.
2. Clean trigger mechanism and
lubricate.
1. Check the air hose and
confirm the hose fitting is
correct for the inlet bushing.
2. Depressurize system and
drain tank and air hose of
water.
3. Ensure tool is connected to a
compressor with a rate flow
that matches the tool.
For technical questions call 1-800-665-8685
V1.0
Publicité
Table des Matières
