Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8843658
14. Do not start the tool when the tool's accessory is touching the
workpiece.
15. Use extra caution when making a 'plunge cut' into existing walls or
other blind areas. You may cut objects that can cause kickback, cut an
electrical wire or a water pipe.
16. Before using the shear, make sure the blades (#32, 38 and 40) are properly
attached to the tool. Be sure the blades are not dull, cracked or bent.
Blades that do not match the tool's mounting hardware will run
erratically, causing loss of control.
17.
The blades will become hot while cutting. Allow the blades to
completely cool before touching.
18. Ensure that the workpiece is properly supported to prevent body
exposure, blade binding or loss of control.
AIR TOOL PRECAUTIONS
1.
Use only clean and dry compressed air as a power source.
Contaminated or moist air will gradually damage the tool.
2.
Install an in-line shutoff valve or regulator to allow immediate control
over the air supply in an emergency, even if a hose is ruptured.
3.
Discontinue tool use if it does not work properly or air is leaking. Tag
or mark the tool as 'defective' or 'out of service' until repaired.
4.
Check the manufacturer's maximum pressure rating for air tools and
accessories. Compressor outlet pressure must be regulated to never
exceed the maximum pressure rating of the tool (see Specifications).
Exceeding the maximum PSI rating can create a bursting hazard,
causing injury and property damage.
5.
Attach all accessories properly to the tool before connecting the air
supply. A loose accessory may detach or break during operation.
6.
Never use oxygen, combustible gas or any other bottled gas as a
power source. Any power source other than an air compressor could
cause an explosion and serious personal injury.
7.
Turn OFF the valve and discharge any remaining air pressure after each
use or before adjusting the tool.
8.
Do not leave the air tool unattended with its compressed air supply on.
Turn off the compressed air supply and bleed the air tool of any
remaining compressed air before leaving the air tool unattended.
6
Straight Grip Air Shear
For technical questions call 1-800-665-8685
V1.0
Publicité
Table des Matières
