Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
8843658
PRESSURE DROP
Apply the air consumption and pressure rate numbers to the tool's air inlet,
not the compressor's outlet. Calculate the pressure drop for your air supply
set-up and increase the compressor outlet pressure to compensate. Make
sure you do not exceed the maximum pressure for any part of your air
supply system.
Installing a pressure gauge at the tool inlet is the best way to measure the
air pressure and adjust the compressor's output.
CARE & MAINTENANCE
1.
Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2.
Inspect the tool fittings, alignment and hoses periodically. Have damaged
or worn components repaired or replaced by an authorized technician.
Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Only use accessories intended for use with this tool.
5.
Keep the tool clean, dry and free from oil/grease at all times.
6.
Maintain the tool's labels and name plates. These carry important
information. If unreadable or missing, contact Princess Auto Ltd. for
replacements.
7.
Do not use dull, dirty or damaged blades. To clean blades, remove the
blade from the tool, clean it with gum and pitch remover, hot water or
kerosene.
a.
Do not use gasoline to clean the blades.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
AIR TOOL LUBRICATION
NOTICE! Only use air tool oil to lubricate the tool. Other lubricants are not
suitable and will damage the tool or cause a malfunction during use.
NOTICE! Never use a penetrating oil to lubricate an air tool. Penetrating oil
acts as a solvent that will dissolve the tool's grease packing and may
damage the o-rings, causing the tool to seize or malfunction.
1.
All air tools have an internal coating of grease to prevent corrosion
during shipping and storage. Remove this grease by adding a generous
10
Straight Grip Air Shear
For technical questions call 1-800-665-8685
V1.0
Publicité
Table des Matières
