Publicité
Les langues disponibles
Les langues disponibles
DM 2610039151 01-16_3D40 1/7/16 9:33 AM Page 33
UPDATING FIRMWARE VIA NETWORK
If your 3D40 is registered and added to your
Dremel3D profile, you can update its
firmware directly from the touchscreen. To
update firmware:
1. Tap "Tools", "Settings", "Check for
Updates".
2. Your 3D40 will check to see if it has the
latest firmware installed and ask if you
would like to update if one is needed.
3. Choose accept to download and install the
latest firmware.
4. When the 3D40 starts up and returns to
the Home Screen, firmware update is
complete.
UPDATING FIRMWARE MANUALLY
If your 3D40 is not connected to a network,
you can update firmware directly from a USB
Flashdrive.
1. On
your
web
www.dremel3d.com/support and download
the latest 3D40 firmware file.
All manuals and user guides at all-guides.com
2. Add the 3D40 firmware file to an empty,
3. Turn off your 3D40 using the ON/OFF
4. Insert the USB flashdrive into the USB-A
5. Turn on your 3D40 and it should
6. Turn your 3D40 OFF, remove the USB
Clean the 3D40's exterior with a lint free
cloth. Clear the outer surfaces of any debris
that is visible.
To avoid damaging your Dremel 3D40 do not
use water, chemicals or other cleaners on
the 3D40.
when clearing debris. Dremel 3D40 will not
work properly with damaged extruder tip and
will require replacement.
operation or until it has cooled down to
60°C (140°F). Contact with the extruder tip
during or after operation before tip has
cooled may result in personal injury.
Using small needle nose pliers, pull away
any plastic debris from the extruder tip.
If the debris is stubborn, the extruder may
need to be heated.
Wipe the touch screen with the soft, lint-free
cloth. Do not spray cleaners on the touch
screen.
browser
go
to
33
FAT32 formatted, USB flashdrive.
switch.
port.
automatically detect and install the new
firmware.
flashdrive, and turn ON again to complete
the update.
CLEANING THE EXTERIOR
CLEANING THE EXTRUDER TIP
Use extra care not to
damage the extruder tip
CAUTION
Do not touch the extruder
tip during Dremel 3D40
WARNING
CLEANING THE TOUCH SCREEN
Publicité
