Publicité
Les langues disponibles
Les langues disponibles
DM 2610039151 01-16_3D40 1/7/16 9:33 AM Page 32
1. ALWAYS USE BUILD TAPE.
2. Ensure your build platform is level before
every object.
3. Ensure spool is installed properly and
can rotate freely.
4. When using your Dremel 3D40 for the
first time or after changing filament, allow
Dremel 3D40 to extrude until material is
consistent with the installed filament
color.
5. It is important to watch your Dremel 3D40
begin building objects. Your object is
most likely to experience difficulty in the
beginning. Thankfully, this is also the
most convenient time to cancel the
object, clean the build platform, and start
your object again. Remain near the
Dremel 3D40 during the building process.
6. It is important to save your Dremel 3D40
packaging as it will make re-boxing and
transporting your Dremel 3D40 easier.
7. Ensure that you store filament spools in
an environment that is not moist or too
hot. It is recommended that you do not
remove the filament spool from its airtight
packaging until use.
UNCLOGGING THE EXTRUDER
Use the unclogging tool to clean the extruder
and unclog built up filament, fig 8.
1. Wait for extruder to heat up, insert the
unclog tool into the extruder intake (top).
2. Clogged debris will be pushed down and
will extrude from the extruder tip.
All manuals and user guides at all-guides.com
Best Practices
8. Use object removal tool gently to avoid
9. Whenever possible, it is best to locate
10. For steep overhangs (Less than 45
11. Always remove the build platform before
12. Low speed sanding is recommended to
13. The Print Studio software will display the
14. Monitor the status of your builds using
Maintenance
32
damaging the build platform or object.
your object in the center of the build
platform. Using the best orientation for
your object is critical. Ensure that your
object is located on the build platform
and that you are using the best
orientation for building.
degree angle) it is recommended to build
with support.
removing the object.
prevent remelting of the object.
length of filament required for each
object. Compare this to the length
indicated on the spool length gauge.
the
Dremel
3D
mobile
Dremel3D.com website.
app
or
FIG. 8
Publicité
