Dremel 3D40 Idea Builder Consignes D'utilisation/De Sécurité page 28

DM 2610039151 01-16_3D40 1/7/16 9:33 AM Page 28
CONNECTING USB CABLE
1. Ensure 3D40 power switch is in the off
position.
2. Connect the included USB cable to your
3D40 and computer, figure 5.
3. Open software.
4. Turn your Dremel 3D40 on using the
power switch to sync your computer to
your Dremel 3D40.
CONNECTING ETHERNET
1. Ensure 3D40 power switch is in the off
position.
2. Plug ethernet cable into your 3D40,
figure 6.
3. Turn your Dremel 3D40 on using the
power switch. Ethernet connection should
be detected automatically. Tap "Accept" to
confirm connection.
Observe
warnings
WARNING
instructions when using the Dremel 3D40.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
Do not reach inside the
Dremel 3D40 while it is in
WARNING
operation. Contact with Dremel 3D40 moving
parts during operation may result in poor build
quality, equipment damage or personal injury.
NOTE: Your Dremel 3D40 will build test
objects before leaving the factory. These test
objects may have been made with a different
filament color than you are using. Therefore,
All manuals and user guides at all-guides.com
Building
all provided
a small amount of filament may be remaining
and safety
in the extruder. The start of your first object
may have some of this filament color until it
transitions over to your filament color.
You have several options when building on
your 3D40:
1) On-Printer Storage
2) USB Flash Drive
3) Online Print Queue
4) Computer
28
FIG. 5
USB
FIG. 6
Ethernet