Publicité
Les langues disponibles
Les langues disponibles
DM 2610039151 01-16_3D40 1/7/16 9:33 AM Page 24
Observe
warnings
WARNING
instructions when using the Dremel 3D40.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
Do not touch the extruder
tip during operation or
WARNING
until it has cooled down to at least 60°C
(140°F). Contact with the extruder tip during
or after operation before tip has cooled may
result in personal injury.
Use only DREMEL filament.
Use
WARNING
authorized by Dremel may result in
equipment and property damage.
Do not pull the filament
out. Doing so may damage
CAUTION
the extruder.
LOADING/CHANGING FILAMENT
1. Start filament load/change process by
tapping "Filament" button on touchscreen.
Extruder will move to front right corner of
print area and extruder tip will begin to
heat.
FIG. 1
Open
All manuals and user guides at all-guides.com
Getting Ready to Build
all
provided
and
safety
2. After extruder stops moving, open the
3. If existing filament is loaded, cut existing
of
filament
not
4. Remove Spool door by rotating it counter
Spool
Holder
Filament
Close
24
3D40 Lid for better access to extruder.
filament near extruder intake and tap
"Next" button on touchscreen.
clockwise and remove existing spool if
one is present, see figure 1.
Filament
Guide Tube
Publicité
