Park Pedal; Solution Tank Filling - Nilfisk SC250 Instructions D'utilisation

PARK PEDAL

NOTE
In order to facilitate the use of the park pedal (10),
slightly lift the front section of the machine by gaining
leverage with your hands on the handlebar (A, Fig.
1).
For parking/handling:
1. Putting your hands on the handlebar (A), slightly lift the
front section of the machine, then press the pedal (B, Fig.
1).
In this condition, the front wheels (11) are resting on the
floor and the brush/squeegee unit is lifted.
For washing/drying:
2. Putting your hands on the handlebar (A), slightly lift the
front section of the machine, then lift the pedal (C).
In this conditions, the front wheels (11) are retracted and
the brush/squeegee unit is resting on the floor.

SOLUTION TANK FILLING

CAUTION!
Use only low-foam and non-flammable
detergents, intended for automatic scrubber
applications.
WARNING!
When using floor cleaning detergents, follow
the instructions on the labels of the detergent
bottles.
To handle floor cleaning detergents, wear
suitable gloves and protections.
1. Remove the tank cover (12).
2. Remove the cap (A, Fig. 2) on the solution tank (B).
3. Fill the solution tank (B) with water, leaving a few
centimetres from the top.
The water temperature must not exceed 40 °C.
4. Use the measurement mark on the cap (A) to mix the
solution.
The capacity to the mark is 30 ml, equivalent to a 0.5 %
solution when diluted in a full tank of water. Always follow
the dilution instructions on the label of the chemical product
used to prepare the solution.
5. Replace the cap (A) on the solution tank.
6. Replace the tank cover (12).
NOTE
Whenever the 2 LEDs on the solution push-button (3)
flash, stop the machine and fill the solution tank.
07/2016
INSTRUCTIONS FOR USE
A
9100001614 - SC250, Scrubtec 334
C
B
Figure 1
B
Figure 2
ENGLISH
P100932
A
P100933
9