Zone Parameters; Production Settings - Airzone FLEXA 3.0 Manuel D'instructions

ZONE PARAMETERS

•
Associated outputs. It displays and allows you to select the control outputs associated with the thermostat.
•
Thermostat settings. Use this parameter to define the thermostat as Master or Zone.
ES
*Note: It cannot be configured as Master if there is already another Master thermostat.
• Use mode. The thermostats can be set in Basic or Advanced mode. They are set in Advanced mode by default. These
are the parameters you can control in basic mode: On/off, set-point temperature, operating mode (only if this is the
EN
master thermostat) and fan speed.
If you need to reset the thermostat to Advanced mode, access the advanced configuration menu and then activate
FR
the advanced use mode.
•
Control stages
IT
cooling and heating stages in a single zone or in all the zones. These are the features to be configured:
- Air: It activates the heating/cooling air in the zone.
PT
- Radiant
DE
- Combined
choose which heating stage to use: Air, Radiant or Combined. The zone will start using the heating air stage. Once
the room temperature reaches the differential preestablished (see parameter
will activate the radiant stage.
- Off: It deactivates the cooling/heating stage in the zone.
•
Offset. Correction of the ambient temperature in the different areas of the system mode in both cold and heat.
•
Reset thermostat

PRODUCTION SETTINGS

Production control board settings are only available in AZX6CCPGAWI for the master Blueface thermostat of the
Important:
system nº1.
•
Operation logic. It allows to configure the operation logic for the control relays of the production control board:
•
Aerothermal unit (Default preset)
•
2 pipes
•
4 pipes
•
RadianT
•
Aerothermal
Mode Demand
Stop
Cooling
Radiant
mode
Heating
Radiant
mode
Dry
Ventilation
32
(only available in installations with AZCE6OUTPUT8 modules).
(only in heating stages)
: It activates the radiant heating in the zone.
(only in heating stages)
(not available in remote zones)
(Recommended for RadianT365 systems)
FRIO_Y CALORB_W
Off --
Air ON
ON
Off --
Air --
--
Off --
On
--
Off
On
--
Off
: It activates the heating air and radiant heating in the zone and lets the user
. It resets the thermostat and returns it to factory values.
Control Relays
AIRE_Y
-- --
-- ON
-- --
-- --
ON --
ON --
-- --
-- --
-- --
This parameter is used to configure both
Hysteresis Configuration
RADIANTE_Y AIRE_W
-- --
-- --
ON --
-- --
-- ON
-- --
-- --
-- --
-- --
), the zone
RADIANTE_W
--
--
--
--
--
ON
--
--
--