System Reset; Zone Reset; Changing Batteries - Airzone FLEXA 3.0 Manuel D'instructions

4.- Other peripherals (AZCE6OUTPUT8, AZX6CCPGAWI, AZX6WEBSCLOUD [C/R], ...)
You can find the instructions on how to connect and configure other peripherals on their data sheets.
Important: For elements externally powered at 110/230 Vac, for their communications, it is only necessary to connect the poles
"A" and "B" of the bus.
ES
5.- Powering the system
EN
Use the power input to power at 110/230 Vac
control elements that require it. Use the appropriate cable (3x1.5 mm²). For added security,
FR
secure the wires using the turret.
IT
PT
DE
Remember: Once all the connections are made, make sure you replace the cover properly.

System reset

If you want to return to factory values, press and hold SW1
LEDS to go back to their normal state before starting with the initial configuration process.

Zone reset

If needed, to reset a zone follow the steps shown in the section
Blueface and Think thermostats and the section

Changing batteries

To replace the battery, separate the thermostat from its support and
replace the battery (CR2450).
We recommend using of top-brand batteries. Using low-
Important:
quality batteries may reduce the duration of use
Remember to deposit the old battery into an appropriate recycling point.
Do not forget to remove the security system before taking away the
Note:
thermostat from the wall.
24
According to the current local and national regulations, it is mandatory to add a switch (or other element
to disconnect the system) to the external supply wiring so that a constant separation between poles is
guaranteed. The system will restart automatically if the supply is eventually turned off. Use an
independent circuit from the controlled system for the power supply.
the main control board and any others
until LED D19 stops blinking. Wait for the
Advanced Settings
Lite thermostat Reset if using Lite thermostats.
.
Zone Parameters
, for