Initial Configuration; Airzone Blueface And Think Thermostats - Airzone FLEXA 3.0 Manuel D'instructions

INITIAL CONFIGURATION

AIRZONE BLUEFACE AND THINK THERMOSTATS

Important: Once the setup has been started, it must conclude. You will be able to modify the desired parameters later.
ES
Language/Country
Select your language and country. These are the available languages: Spanish, English, French, Italian, German and Portuguese.
EN
To associate a wireless Think thermostat, start the radio channel search:
FR
Setting wireless device
- Open the radio channel. To do that, press on SW1. The LED D19 will remain solid red. Once
IT open, you have 15 minutes to make the association. If that period of time expires, start the
process over again. Remember not to open more than one module at the same time, it may
alter the process. You can also open the channel association radio through the Blueface and
PT
Think (see section
IMPORTANT: not to open more than one radio channel at the same time, it may alter the
DE
process.
- Start the radio channel search, to do so, press Airzone to start the search.
- Verify the range is correct (30% minimum) and confirm.
Zone address
Select the zone associated to the thermostat. Each zone corresponds to a radiant element relay output. For example, zone 1
will control the relay output O1 of the airzone control module of radiant elements (AZCE6OUTPUT6).
Associated outputs
If necessary, the system allows you to associate more than one control output to a zone. It is possible to control multiple outputs
from the same thermostat.
Thermostat settings
Select the operation of the thermostat:
- Master: Controls all the parameters of the installation.
- Zone: Controls all the parameters of the zone.
Control stages (only available in installations with AZC6OUTPUT8 modules) *
Select the stages to be controlled: Air, Radiant or Combined.
Other settings
Press to finish the initial setup process, or access the advanced settings (system address, control stages, etc.) to change any
other settings. Activate the basic function* if required (see
*(Not available on 3.5.0 version AZCE6THINKR)
26
System parameters
).
Advanced Settings Zone settings
, ).