Airzone Lite Thermostat - Airzone FLEXA 3.0 Manuel D'instructions

ES
EN
FR
IT
PT
DE

AIRZONE LITE THERMOSTAT

Important: To configure a Lite thermostat you must move it away from its base. Once the microswitches are configured, put it
back in its original position.
Setting wireless device
Open the radio channel. To do that, press on SW1. The LED D19 will remain solid red. Once open, you
have 15 minutes to make the association. If that period of time expires, start the process over again.
Remember not to open more than one module at the same time, it may alter the process. You can also
open the channel association radio through the Blueface and Think (see section
IMPORTANT: not to open more than one radio channel at the same time, it may alter the process.
Zone address
Select the zone associated to the thermostat pulling up the microswitch of the corresponding zone.
Associated outputs
If required, select other control outputs associated to the zone. The address zone will be the one with a lower value.
28
(only available for wireless thermostat)
System parameters
).