Airzone FLEXA 3.0 Manuel D'instructions page 25

1.- Thermostat connection
If using a wired thermostat, connect it in one of the 3 Airzone connection bus terminals.
The connection can be both a Bus connection or a star connection. Use (2x0.5+2x0.22
mm 2 ) Airzone wire. For added security, secure the wires using the turrets.
In case of wireless element, check it has the battery on.
2.- Connecting the motorized elements
Connect each output to the actuator
control zone. Identify the actuator outputs to facilitate the
maintenance. Do not connect more than two actuators per output.
Use the Airzone cable (2x0.75 mm
recommended length: 20 m.
3.- Connection to the ducted unit
- Through gateway: Connect the communication gateway to the AC unit port of the main control board
connect it to ducted unit, follow the instructions of the communication gateway. It is recommended to install the
thermostat of the unit. For the connection of DIN rail gateways, use (2x0.22 mm
the connector of the main control board).
- Through Start-Stop: Use the main control board relay
manufacturer's instructions. I
Thermostat
of its corresponding
) for the connection. Highest
2
1 A, V 24 / 48 Vdc.
max max
Press
2 ) Airzone wire (Use the shield only on
to perform the start-stop of the unit following the
ES
EN
FR
IT
PT
DE
. In order to
23