Rotel RC-972 Manuel De L'utilisateur page 2

RC-972 Stereo Control Amplifier
2
WARNING: There are no user serviceable parts in-
side. Refer all servicing to qualified service personnel.
WARNING: To reduce the risk of fire or electrical shock,
do not expose the unit to moisture or water. Do not
allow foreign objects to get into the enclosure. If the
unit is exposed to moisture, or a foreign object gets
into the enclosure, immediately disconnect the power
cord from the wall. Take the unit to a qualified ser-
vice person for inspection and necessary repairs.
Read all the instructions before connecting or operating the
unit. Keep this manual so you can refer to these safety in-
structions.
Heed all warnings and safety information in these instruc-
tions and on the product itself. Follow all operating instruc-
tions.
Clean the unit only with a dry cloth or a vacuum cleaner.
Keep the ventilation inlets on the unit unobstructed. For ex-
ample, do not place the unit on a bed, sofa, rug, or similar
surface that could block the ventilation slots. If the unit is placed
in a bookcase or cabinet, there must be sufficient clearance
around the unit and ventilation of the cabinet to allow proper
cooling.
Keep the unit away from radiators, heat registers, stoves, or
any other appliance that produces heat.
The unit must be connected to a power supply only of the type
and voltage specified on the rear panel of the unit.
Connect the unit to the power outlet only with the supplied
2-pin polarized power supply cable or an exact equivalent.
Do not modify the supplied cable in any way. Do not attempt
to defeat grounding and/or polarization provisions. The cable
should be connected to a 2-pin polarized wall outlet, match-
ing the wide blade of the plug to the wide slot of the recep-
tacle. Do not use extension cords.
Do not route the power cord where it will be crushed, pinched,
bent at severe angles, exposed to heat, or damaged in any
way. Pay particular attention to the power cord at the plug
and where it exits the back of the unit.
The power cord should be unplugged from the wall outlet if
the unit is to be left unused for a long period of time.
Immediately stop using the unit and have it inspected and/
or serviced by a qualified service agency if:
• The power supply cord or plug has been damaged.
• Objects have fallen, or liquid has been spilled, into the unit.
• The unit has been exposed to rain.
• The unit shows signs of improper operation
• The unit has been dropped or damaged in any way
Place the unit on a fixed, level surface
strong enough to support its weight.
Do not place the unit on a move-
able cart that could tip over.