Safety Information - Degometal GO 3313 Consignes De Sécurité Et Mode D'emploi

Safety information

Quick charger
Caution !
The following safety rules must be observed to ensure adequate protection against
electric shock, injuries or fire hazards:
●
The charger must only be used to charge rechargeable batteries.
Regularly check the plug, power cable and charger and have them
●
repaired by Service or by an authorised electrician when damaged.
Use only genuine power cables and genuine spare parts for repairs.
●
Never use the charger in a humid or wet environment or close to
●
flammable liquids or gases. Danger of explosion!
●
Take the charger out of its packaging before use.
●
Using minimum force, insert the battery in the correct position
(+pole to +pole) into the charger.
●
Never try to charge non-rechargeable batteries.
Store the charger in a dry, closed room and out of the reach of
●
children.
●
Never insert metallic parts into the battery compartment - danger of
short circuiting.
If the charger is wall-mounted, make sure that external influences
●
(e.g. vibration) cannot
●
cause the battery to fall out of the charger.
●
The battery charger is designed only for use at altitudes up to 2000
m above sea level.
This battery charger must not be operated by persons with restricted physical, sensory
●
or mental abilities nor by inexperienced or unskilled persons unless they are
supervised by someone who is responsible for safety or receive instructions from them
on how to use the charger
Rechargeable Battery
Caution !
The following safety rules must be observed to ensure adequate protection against electric
shock, injuries or fire hazards:
●
Never try to charge a damaged battery.
Do not insert a dirty or wet battery into the charger.
●
Never discard batteries into household waste, fire or into water.
●
Do not charge batteries at a temperature below 0℃!
●
Charging Procedure
Only charge batteries at a temperature between 0℃ and 40℃!
●
Take the quick charger out of its packaging and connect to the power
●
●
supply. Pay attention to the voltage specified on the rating plate!
●
Using minimum force, insert the battery in the correct position (+pole to
●
+pole) into the charger.
●
The charging operation starts automatically.
www.degometal.com
21