Repairs; Troubleshooting; Blind Rivet Nut Does Not Screw On - Degometal GO 3313 Consignes De Sécurité Et Mode D'emploi

Function indicators
Steady green
Flashing green
Steady red
Flashing red
Charging times
Battery Charging
type time(2.4A)
approx. ≤60 min
2.0 Ah
approx. ≤120 min
4.0 Ah
* Charging times may vary depending on the residual capacity and the battery temperature.
Battery care
To achieve an optimum charge, allow the battery to cool down before inserting it in the charger.
The battery can be recharged approx. 1000 times and reaches its full capacity after several charges.
Do not insert the battery into the charger after each use.
Only charge the battery when it is discharged and blind rivet nuts can no longer be set. Only recharge
the battery after a prolonged idle period.
Significantly shorter battery operating times, despite proper recharging, indicate that the battery
needs to be replaced.
Store batteries in a dry place where there is no danger of frost. The optimum operating temperature
range is 10 ℃ to max. 50 ℃.
Environmental Protection
If batteries need to be replaced, please observe the following:
●
Return used rechargeable batteries to your dealer or to for recycling.
Never discard used batteries into household waste, fire or into water!
●
Caution!
In all EU countries the relevant national regulations for implementing the EU guideline shall apply.
In accordance with the EU Directive 2002/96/EC (WEEE), in Germany, this tool is regis- tered under
●
the WEEE Reg.-No. DE 45695505. If the tool has an 8-digit serial number it can be returned free of
charge to for correct disposal.

3. REPAIRS

Repairs under warranty are carried out by the manufacturer. Repairs outside the warranty pe- riod
should only be carried out by skilled technical personnel. Failure to observe the assembly and setting
procedures and operation by non-skilled personnel may result in serious damage to the blind rivet nut
setting tool. In case of doubt, always send in the blind rivet nut setting tool to the supplier

4. troubleshooting

Blind rivet nut does not screw on

Cause
Nut thread defective
Threaded mandrel A defective
Battery charged / trickle charging
Charging
Impermissible charging temperature
Battery defective
www.degometal.com
Corrective measures
Use new nut
Change threaded mandrel A
Threaded mandrel length x incorrect; adapt to nut length
22