Degometal GO 3313 Consignes De Sécurité Et Mode D'emploi page 19

Start-up
Before starting the riveting tool, read and observe the operating instructions as well as safety information
and keep in a safe place.
●
Insert fully charged battery in correct position into the blind rivet nut setting
tool.
Select nosepiece and threaded mandrel from Table 2.6 and screw on (M6
●
in working position
).
Caution !
The air inlets for the motor must not be obstructed; do not insert any objects into them.
A. Setting the threaded mandrel length x (Fig. 2)
Set the threaded mandrel length x to the blind rivet nut length by
●
turning the nosepiece B.
● Fully utilise the thread depth of closed blind rivet nuts (Fig. 2; 4).
Secure setting of nosepiece B with lock nut C.
●
B. Adjusting the setting stroke y (Fig. 2)
●
The setting stroke y depends on the size of the blind rivet nut
(M3-M10) and of the rivetable material z (Fig. 4).
Reference values for setting stroke y:
Threadsize
M4
M5
M6
M8
M10
The setting stroke y is adjusted by screwing the setting nut D in and out.
●
Caution !
● Initially adjust the setting stroke y to the "min." value and then set a blind
rivet nut.
If the blind rivet nut does not form a distinct closing as shown in Fig. 4 ,
●
increase the setting stroke y in steps.
Secure the setting nut D with lock nut E.
●
Setting Stroke y (in mm)
min.
1
1.5
2.5
2.5
3
www.degometal.com
max.
2
2.5
3.5
3.5
4
19