Operation With The "4 In 1 Nozzle; Operation With The Sprinkler Attachment; Work Interruptions; Battery Status Indicator - Gloria MULTIJET 36V Mode D'emploi

flows, switch the device back to "spray"
mode.
7.4.1 Operation with the "4 in 1
nozzle"
Combine the set pressure with the "4 in 1
nozzle". We recommend the following
settings, for example:
+ = cleaning of larger
areas that are
moderately dirty
spray eco clean
+
+ = cleaning of larger
areas that are very
dirty
spray eco clean
+ = spot cleaning that
are very dirty
ATTENTION
Ensure that you are standing firmly since
the water jet can produce a greater or lesser
degree of recoil force at the device
(depending on the operating mode that
was selected). Always hold the spray gun
and spray pipe firmly with both hands.
ATTENTION
The high pressure can cause damage! If the
water pressure is too high, it can damage
the surfaces. Maintain a distance of at least
30 cm from painted surfaces. Do not clean
delicate surface with the turbo mill (e.g.
wood, tires, painted surfaces, etc.).
15
Switch on the spray jet by pressing the
trigger (L) in the handle of the spray gun
(N) and start cleaning.
16
NOTE!
Press the PowerControl button (M) for eas-
ier and less strenuous work. This signifi-
cantly reduces the resistance on the trigger
(L)!
7.4.2 Operation with the sprinkler
attachment
Attach the sprinkler (J) for plant and
17 18
-
garden irrigationand start watering.
= Sprinkler
Combine the set pressure with the sprin-
kler (J). We recommend the following
settings, for example:
+
spray eco clean

7.4.3 Work interruptions

19
If you need to stop working, release the
trigger (L) on the spray gun (N) and lock
the trigger (L).
This will switch off the pump in the
remain ready for operation. If the device is
not used for longer than 5 minutes, the
mode (indicators flashes green).

To switch on the
again, unlock and then press the trigger
(L) on the spray gun (N). The device will
continue operating in the most recently
selected setting.

If the device is not used for longer than
30 minutes, it will switch off. To restart
the device, press the ON/OFF-switch
(A). The device then starts in "spray"
mode.

7.4.4 Battery status indicator

The device is equipped with a battery
charge indicator (B) that displays the
charging status of the battery. The dis-
plays only light up when the device is
switched on.
Battery capacity:
max
Reserve ≤ 30%
Temperature protection
max
Low voltage cutoff:
max
The indicator (B) will flash green shortly
before the low voltage cutoff device
switches off the device. If the low voltage
cutoff device switches off the device, all
four indicators (B) will flash green.
32
= Watering plants
but the device will
will switch to standby
max max
max
≤ 60% 100%
max