Operation; Operation With The "4 In 1 Nozzle; Work Instructions - Gloria MULTIJET Mode D'emploi

We recommend the following settings
+ Press trigger (M).
ATTENTION
Damage to the device due to dry running If
the device does not produce any pressure
within max. 1 minute, this may cause dam-
age to the device. Switch the device off
immediately and follow the instructions
given in section 9 "Problems with the device.

6.4 Operation

CAUTION
Make sure that the main switch for the
power supply (V) is in position "0" before
you connect the device to the mains.
11
1. Connect
power cord (J) to the mains.
2. For the power supply switch on the
(V).
3. Now switch the
with the ON/OFF motor-softkey button
(A) on
4. Set the optimum spray pressure for the
application at the operating mode button
(C).
= 0,5 MPa (5,0 bar)
= 5,0 MPa (50 bar)
= 7,5 MPa (75 bar)
At the "4 in 1 nozzle" (F), set the water
12
spray form that is optimal for your appli-
cation.
= Flat jet 15°
= Flat jet 60°
= Turbo mill
with the
at the main switch
27
= Needle jet
We recommend the following settings,
for example:
= plant protection products set
(accessory, not included as stan-
dard)
NOTE!
When using the plant protection lance (part
of the plant protection set) it may not be
possible to suck in sufficient liquid in the
"spray" mode. In this case, switch the device
briefly to "eco" until the intake hose (H) has
filled. As soon as sufficient liquid flows,
switch the device back to "spray" mode.
6.4.1 Operation with the "4 in 1
nozzle"
Combine the set pressure with the "4 in 1
nozzle". We recommend the following
settings, for example:
+ = cleaning of larger areas
that are moderately
dirty
+
+ = cleaning of larger areas
that are very dirty
+ = spot cleaning that are
very dirty
Switch on the spray jet by pressing the
13
trigger (M) in the handle of the spray gun
(P) and start cleaning.
NOTE!
Press the PowerControl button (N) for
14
easier and less strenuous work. This sig-
nificantly reduces the resistance on the
trigger (M)!

6.4.2 Work instructions

ATTENTION
The high pressure can cause damage! If the
water pressure is too high, it can damage
the surfaces. Maintain a distance of at least
30 cm from painted surfaces. Do not clean
delicate surface with the turbo mill (e.g.
wood, tires, painted surfaces, etc.).