Water Supply From A Water Tap; Water Supply From Open Containers; Operation - Gloria MULTIJET 36V Mode D'emploi

10
Insert the filter seal (T) and screw the
coupling for the water connection (S)
onto the water connection on the
device (Q) as shown in the illustration.

Make sure that the surface to be cleaned
is free from debris such as stones, screws
etc., which could be flung up.

7.2 Water supply from a water tap

Connect to the water supply as described in
section 4 "Technical data". Observe the basic
safety instructions in chapter 2.1.
11
Connect the coupling of the supplied
intake hose (H) to the device. Now con-
nect the intake hose (H) to the water
supply and turn the tap on fully.
ATTENTION
Improper use of the device poses a risk
of damage to property! You should
therefore observe the following safety
instruction:

If the pressure in the water pipe is bigger
than 0.5 MPa (5 bar), please use a pressure
reducer.
7.3 Water supply from open
containers
Instead connecting to a tap, the device can
also be supplied with water from open con-
tainers such as rainwater barrels, buckets,
ponds, etc. Note the maximum suction head
stated in section 4 "Technical data".
The suction time increases as the suction
head increases.

Connect the coupling of the supplied
intake hose to the device.
12
Install at the other end of the hose the
intake filter (G) to the coupling and hang
the hose in eg. a rain barrel.
ATTENTION
Damage to the device due to dry running
If the device does not produce any pres-
sure within max. 2 minutes, this may
cause damage to the device. Switch the
device off immediately and follow the
instructions given in section 10 "Problems
with the device.

7.4 Operation

CAUTION
13
Switch the
the ON/OFF- switch (A) on and set the
optimum spray pressure for the applica-
tion at the operating mode button (C).
= 0.5 MPa (5.0 bar)
spray
= 2.5 MPa (25 bar)
eco
= 4.6 MPa (46 bar)
clean
14
At the "4 in 1 nozzle" (F), set the water
spray form that is optimal for your appli-
cation.
= Flat jet 15°
= Flat jet 60°
= Turbo mill
= Needle jet
We recommend the following settings,
for example:
= plant protection products
set (accessory, not included
as standard)
spray eco clean
NOTE!
When using the plant protection lance
(part of the plant protection set) it may not
be possible to suck in sufficient liquid in
the "spray" mode. In this case, switch the
device briefly to "eco" until the intake hose
(H) has filled. As soon as sufficient liquid
31
with