Unpacking; Commissioning; Attaching The Add-On Parts; Water Supply From A Water Tap - Gloria MULTIJET Mode D'emploi

5

Unpacking

-
Figures
1 2

Your device is supplied pre-assembled.
The loose parts that are included must
be installed accordingly, depending on
the application.
6

Commissioning

-
Figures
17
3
DANGER
DANGER OF ELECTRIC SHOCK!
BEFORE COMMISIONING OBSERVE
CHAPTER 2 "FOR YOUR SAFETY".
The operating voltage is 230 V AC, 50
Hz (for non-EU countries 220 V, 240 V
as applicable). Contact your nearest
authorised specialist dealer for details.
DANGER
Inadequate extension cables can be
dangerous. Extension cable, plug and
socket must be of watertight construc-
tion and intended for outdoor use.
If you want to use an extension cable
when operating your high pressure
washer, only the following cable
dimensions should be used:
2
- 1,5 mm – max. length 20 m
- 2,5 mm 2 – max. length 50 m
NOTE!
If an extension cable is used it must be
earthed and connected through the
plug to the earth cable of your supply
network in accordance with prescribed
safety regulations. The mains plug and
coupling of the extension cable must
be water tight and may not be placed in
water. The coupling may not be on the
floor.

6.1 Attaching the add-on parts

- Insert the pressure hose (I) into
3 4
the connection (X) on the
in the illustration. Then insert the
pressure hose (I) into the coupling
Now attach the spray pipe (E) to the
5
spray gun (P) as shown in the illustra-
tion. Secure the connection with the
union ring (D) so that it is finger-tight.
Then attach the "4 in 1 nozzle" (F) to
6
the spray pipe (E) as shown in the illus-
tration.
Mount the spray gun holder (W) on the
7
device as shown in the illustration.
Insert the filter (T), the seal (S) in the
8
coupling for the water connection (U)
and screw the assembled unit onto the
water connection on the device (R) as
shown in the illustration.

6.2 Water supply from a water tap

Connect to the water supply as described in
section 4 "Technical data". Observe the basic
safety instructions in chapter 2.1.
Connect the coupling of the supplied
9
intake hose (H) to the device. Now con-
nect the intake hose (H) to the water
supply and turn the tap on fully.
ATTENTION
Improper use of the device poses a risk
of damage to property! You should
therefore observe the following safety
instruction:

If the pressure in the water pipe is bigger
than 0.5 MPa (5 bar), please use a pressure
reducer.
6.3 Alternative water supply
from open containers
Instead connecting to a tap, the device can
also be supplied with water from open con-
tainers such as rainwater barrels, buckets,
ponds, etc. Note the maximum suction head
stated in section 4 "Technical data".
The suction time increases as the suction
head increases.

Connect the coupling of the supplied
intake hose to the device.
Install at the other end of the hose the
10
as shown intake filter (G) to the coupling and hang
the hose in eg. a rain barrel.
26
on the spray gun. All connections
must audibly click into place.