Instructions Of The Remote Control; Connection Diagram - Sonnenkonig LIVORNO Mode D'emploi

7 Instructions of the remote control

The unit has a remote control for convenient and efficient use. For the remote control to work, it
must always be pointed at the fan.
Before using the remote control, please take a few minutes to familiarise yourself with the fun-
ctions:
LIGHT ON/OFF: Press the button to switch the light on the unit on or off.
LOW: Press this button to select the low speed.
MED: Press this button to select the average speed.
HI: Press this button to select the high speed.
STOP: Press this button to turn off the unit.
1H-8H: Use these buttons to control the timer function.
Change the batteries by sliding the cover down as shown by the arrow. (1.5V
/ AA, 2 pieces)
To operate the ceiling fan with the remote control, the supplied receiver must be installed be-
forehand as described in the „Installation" section of this manual. To use the remote control, you
must insert 2 batteries into the bottom of the remote control.
of the remote control.
LEARNING HOW TO USE THE REMOTE CONTROL
For turning on the receiver, press and hold the "STOP" button for 3 seconds. Light will (if instal-
led) blinks 2 times. They will be synchronized when hear a prolonged signal.

8 Connection diagram

Neutral (white)
Phase (black)
Connection to the
power supply
Receiver
Antenna
53 53
Neutral (white)
Phase (black)
Connection
to the fan
EN