Electrical Connections - Sonnenkonig LIVORNO Mode D'emploi

ELECTRICAL CONNECTIONS

E-Line: Green+Yellow
MOUNTING THE WINGS
Remove the receiver from the remote control and
slide it under the hemisphere of the fan. Be careful
L-Line: Black
not to damage the receiver's side cables. Connect the
N-Line: White
E-Line: Green+Yellow
eclectic network to the terminal or domino located
on the mounting plate. Be careful, do not reverse the
phase and neutral cables. Pay attention to the black
cable, this is the receiving antenna.
Empfänger
Connect the cables that come out of the fan with the
plug to the cables of the Domino's output. Make sure
that the cables are properly connected to the terminal
block. Working carefully with the cables without for-
cing the connectors, reassemble the canopy. Rotate
the canopy to secure it in its housing, use the screws
to secure the canopy.
Find the marks to install 3 wings on the motor. Place
the three wings without tightening them to the end at
this point.
When the three wings are installed, adjust them so
that the distance between the wings is minimal. Now
tighten the screws to the maximum.
CAUTION! Do not operate the fan without the blades
installed . The motor is equipped with a safety mode
that prevents normal operation of the motor.
51 51
EN