Preparation - Sonnenkonig LIVORNO Mode D'emploi

4 Preparation

Important: When using an existing outlet box, make sure the box is securely attached to the
EN
building struc-ture and can support the full weight of the fun. Failure to do this can result in
serious injury or death.
Tools needed to install your fan:
- A drill
- Magnetic Phillips screwdriver
- Flat magnetic screwdriver
Check to make sure blades are at least 60 cm from any obstruc-tion. Check downrod length to
ensure blades are at least 2.3 m above the floor.
Turn off circuit breakers and wall swich to the fan supply line leads. War-
ning: Failure to disconnect power supply prior to installation may result
in serious injury or death.
Determine mounting method to use.
A: closemount
B: Downrod mount or angle mount. (only some models)
Important: If using the angle mount, check to make sure the ceiling angle
is not steeper than 25°
48
48 48