Sonnenkonig LIVORNO Mode D'emploi page 50

COPPLING
Take the canopy and the decorative motor cover, and
slide it through your
chosen rod. Take the cables coming out of the motor
and push them into the lower rod so that they come
EN
out the other side. Attention, put the rod in the right
direction, the hemisphere hole upwards and screw
hole downwards to the motor.
Now take the hemisphere, push it through the rod, set
the cylinder, mount the hemisphere to block the cylin-
der and screw the hemisphere tight. Be careful not to
break or bend the cables.
Attach the rod to the bottom of the motor over the
coupling located above the motor as shown in the fol-
lowing figure.
Pass the through bolt through the coupling and the
rod, careful for the cables!
Guide the pin, then screw the three screws around the
coupling, the ceiling rod should not move, it must hold
tight. Slide the decorative cover down, screw it tight.
Finally, place your fan on the mounting plate, the
hemisphere goes into the mounting plate, make sure
the pin on the plate goes well into the groove of the
hemisphere.
50
50