PEERLESS SGLS01 Installation Et Assemblage page 9

For Flat Back Screen
13-1
Refer to Screen Compatibility Chart to determine the proper fastener to use. Visit
for a full screen compatibility chart for this mount.
Begin with the shortest length screw, hand thread through multi-washer and adapter bracket into screen as shown
below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten.
If screw cannot make three full turns into the screen, select a longer length screw from the baffled fastener pack.
Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
For Bump-out or Recessed Back Screen
Refer to Screen Compatibility Chart to determine the proper fastener to use. Visit
13-2
for a full screen compatibility chart for this mount.
Begin with longer length screw, hand thread through multi-washer, adapter bracket and spacer in that order into
screen as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do
not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the baffled
fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
Visit Peerless website at www.peerlessmounts.com
SCREEN
BRACKET (G)
SCREEN
SPACER
9 of 33
fig. 13.1
MULTI-WASHER
SCREW
ADAPTER
fig. 13.2
MULTI-WASHER
SCREW
ADAPTER
BRACKET (G)
ISSUED: 07-28-06 SHEET #: 202-9156-8 11-10-08
For customer care call 1-800-729-0307 or 708-865-8870
www.peerlessmounts.com/2
www.peerlessmounts.com/2