Sym LV30/25/12W1-EU Série Manuel D'utilisation page 10

7. Use of each component
1. "M" button :
 Total odometer, trip odometer, oil change trip meter modes
Push the "M" button to switch the display among the odometer mode "TOTAL", the trip meter mode "TRIP",
and the oil change trip meter mode "OIL" in the following order:
 Clock display and setting modes
1.
Showing 24-hour clock system. 0:00~23:59 (HH:MM)
2.
After the main switch is on, the clock will show hour and minute.
On the "CLOCK" mode and the vehicle is standing still, press "M" for above 2 seconds to enter clock
3.
setting mode. Press "S" button shortly to increase the hour readings, once per one time. Then press "M"
for 2 seconds to enter tenth minute setting. Increase the tenth minute readings by pressing "S" button
once per one time. Again press "M" for 2 seconds to enter unit minute setting. Increase the unit minute
readings by pressing "S" button once per one time. Press "M" button for above 2 seconds to exit
"CLOCK" setting mode.
CLOCK-HOUR
(flashing)
2.
On the "TRIP" display mode, press "S" for 2 seconds to reset the trip
3. "S" button : readings.
a. On the "CLOCK" mode, press "S" button shortly to shfit between CLOCK & VOLTAGE displays.
 Oil service accumulated kilometers mode
a. The oil change trip meter shows the distance traveled since the engine oil was last changed and this
trip meter was reset.
b. At the initial 1,000km, engine oil should be changed and then at every 5,000 km thereafter. It warns
the user to check or change engine oil when the oil change indicator lights on, After changing the
engine oil, be sure to reset the oil change trip meter because oil change indicator works in
conjunction with the oil change trip meter and must be reset.
c. On the "OIL" mode, press the "S" button twice very quickly will reset oil service accumulated
kilometers and turn off 〝OIL CHECK〞indicator, moreover, on the "OIL" mode, oil service
accumulated kilometers can be reset at any time.
d. If the engine oil is changed before the oil change indicator on (i.e. before the periodic oil change
interval has been reached), the oil change trip meter must be reset in order for the next periodic oil
change to be indicate at the correct time.
CAUTION:

If the battery voltage is below 10.0V when the main switch is on, the light system is off and the engine is
not started, check the battery at SYM dealer.

If the battery voltage is below 10.0V or over 16.0V when the vehicle is moving, check the battery at SYM
dealer.
TOTAL
CLOCK-MIN(10min)
(flashing)
TRIP
CLOCK-MIN(1min)
"OIL"
8
OIL
(flashing)