Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10. Inspection and maintenance before riding
WARNING:
Oil level will not be correct when checking the oil level with the scooter parked on an unleveled
ground or immediately after the engine stopped.
Engine and exhaust pipe are hot right after engine stopped. Pay special attention not to get burned
when checking or replacing engine oil.
FUEL INSPECTION
Turn main switch key to "ON" position, and check fuel gauge's needle range to make sure there is enough
amount of fuel in the fuel tank.
This scooter's engine is designed for using the unleaded fuel of Octane 92(RON) or greater.
Firmly secure the main stand on the ground, shut off the engine and keep flames away from the scooter
when refueling.
Do not fill below fuel lower limit level when refueling.
Make sure the fuel tank cap had been tighten properly.
TRANSMISSION OIL INSPECTION AND CHANGE
INSPECTION:
Use the main stand to support the scooter on a level ground, after
the engine stops, wait for 3~5 minutes. Remove the transmission oil
infusion bolt, put a measuring glass under the drain bolt, and
remove the drain bolt. Let the oil flows into measuring glass and
check for decreased or not.
( 300cc：at disassembly: 180 cc. / at change: 160 cc).
OIL REPLACEMENT:
Stop the engine and use the main stand to support your scooter on
a level ground. Remove the infusion bolt and drain bolt, drain out
the oil.
Install the drain bolt and tighten it. Refill new transmission oil, and
install the infusion bolt and tighten it. (make sure that bolts are
tightened and check that there's no leakage.)
※ Recommend Oil:
Genuine SYM〝SYMOIL〞GEAR OIL (SAE 85W-140 GL-5).
Use SAE85-90 when outside temperature is below 0℃.
【Oil Mesh Filter Cleaning】
Open the filter nut assembly of the element, and
remove the element. Remove the foreign materials
from the element by using a gasoline or air spraying
gun.
Transmission
oil pours into
Gear oil draining bolt
16
Publicité
Chapitres
Table des Matières
