afx light LEDWASH 715 Manuel D'utilisation page 3

2. Connection of Signal Cable
You can use the 3-pin XLR cable to connect the output socket of the master and the input socket of the slave light.
Connect the DIGITAL OUT socket of the master and the IN socket of the slave light, then, connect the OUT socket to
the IN socket of the next light. Ordinal to connect all the lights as below:
1 2
IN
O U T
The connection between the output of master and input of product, it's available to use the 3 pins XLR cable which
provided by the manufacturer. Signal cable from the DMX output of the controller to the input of the first master light,
and connect to the DMX input of second slave light from the DMX output of the first master light, analogously, till
connected all the slave lights, and insert the last connector to the output of the final light. (Notice: the diameter of core
of every cable should be 0.5mm at least, double core shelter cable should be used).The signal connecting must use
the attached 3 pins XLR cable. Notice, all the internal lead wire of the 3 pins XLR cable should not touch to each other
or connect to the connector.
DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR connector with a 120Ω
resistor between the pin 2 and pin 3 of the XLR connector
TFT PANEL DESCRIPTION
There are total four operating buttons on the control panel, you can simply set the starting address, run the pre-programmed program or make a
reset.
<Mode/Esc>
Used to scroll through the current operating mode, as well as back out of the current menu option.
<Up>
Used to select increasing advancement in the value.
<Down>
Used to select decreasing advancement in the value.
<Enter>
Used to select a value and store it to memory.
The control panel shows the current state of the unit. It is used to select the operating mode, as well as the sub-features. For a detailed lay out of
the control panel functions, please see the following page.
Set DMX Address
DMX Value
Work Condition Slave Mode
Channel test
Auto Program
Sound Control
Program selection
Programming
Edit Prog
Manual Scene REC
Auto Scene REC
User Mode
User Mode Set
Edit User Mode
No DMX Status
Language
Pan Reverse
Tilt Reverse
Pan Degree
Option
Display Reverse
Sleep latency
XY_Reset
All_Reset
Sound active Sensitivity
Encoder
Parameters Pan correction
Tilt correction
Factory Reset
SWVER
Run info Use time
Total use time
©Copyright Lotronic 2014
3
IN IN
O U T
A001-AXXX
Pan, Tilt, Dimmer,...
Slave1, Slave2, Slave3
Test effect can be saved as a desktop. Desktop Scene: when no signal display scene(depends
on no signal model wether set as desktop or not)
Master/Slave
Master/Slave
Programming: select 3 of 10 program to drive
Scenario number: 10 program(0-9)
Start scenario: the first scenario is 0-XXX
End scenario: the end scenario is 0-XXX
Device record to drive the scenario
DMX controller record to drive the scenario
Standard/Basic/Extended/User A/User B/User C(User A,B,C can modify, others can't. DMX
value see DMX menu.
Can modify original channel order, whether need this channel or not(set 0 close this channel)
Close/Scene/Auto/Music
Chinese/English
Yes/No
Yes/No
540'A, 540'B,630'
Yes/No
05-20 (min/second), auto into sleep when time over
Motor Reset
Back to start location after reset
0-99%
Yes/No
0-255
0-255
O U T
LEDWASH 715