Télécharger Imprimer la page

gdw 1235 Notice De Montage page 5

Publicité

Les langues disponibles

Les langues disponibles

Mazda E2200 P.U.
2000 - ....
Ref. 1235
Fitting instructions
1)
Permanently remove the towing ring in the rear. Remove the spare wheel.
2)
Place the mounting pieces (-e) and (-f) in the rear with points (A) against the bottom of the chassis on the
existing holes. Place at point (A) the mounting pieces (-g) and (-h) in the chassis, matching points (A) and
(B) on the existing holes.
Insert the bolts; in sert bolts and washers at point (C), but do not tighten them yet.
3)
Place the tow bar with points (D) and (D') of the mounting pieces (-e) and (-f) on the points (D) and (D')
of the tow bar. Insert the bolts and washers and tighten everything firmly.
Reinstall the spare wheel.
Composition
1 tow bar reference 1235
1 flange ball 50T
2 bolts M16x45 + nuts
4 bolts M12x35 + nuts
2 bolts M12x35
8 bolts M10x35 + nuts
4 washers 40-12-4
2 safety washers M16
6 safety washers M12
8 safety washers M10
1 mounting piece (-e)
1 mounting piece (-f)
1 mounting piece (-g)
1 mounting piece (-h)
Note
Please consult your cardealer or owners manual for the maximal permissable towing mass.
Remove any bitumen coating on the fastening position for the tow bar.
When drilling, be carefull not to damage any brake lines, electrical wiring or fuel lines.
(*)
(*)
(A-D')
(D)
(B-C)
(C)
(*)
(A-D-D')
(B-C)
(D-D')
(D-D')
(A)
(A)
All bolts and nuts: quality 8.8

Publicité

loading