Joie i-Juva Manuel D'instructions page 6

9
1
2
4. Open the lock-off and route the vehicle safety belt through the
-1
belt path , and lock it into the buckle.
9
5. Tighten the vehicle safety belt as much as possible while pushing
down on the base, and check it is not loose or twisted, then close
-3
the lock-off.
9
!
The infant child restraint can not be used if the vehicle safety belt
with female buckle is too long to tie the base.
!
Check that the safety belt does not move by pulling and pushing
hard on base. If belt loosens or lengthens, repeat procedure.
9
3
4
-2
9
-4
9
6. The installed base is shown as
!
Please ensure that there is no gap
between the seat and the bottom
of the base.
!
The safety belt must go under the
lock-off, not over the lock-off.
-1
!
The safety belt must be locked into
-2
the buckle.
10
!
The load leg must be installed
correctly with green indicator.
7. Push the infant carrier module
down into the base.
11
.
10
10
10
-3
10
2
11
1
3
10