Joie i-Juva Manuel D'instructions page 5

Handle Adjustment
see images -
4 5
The handle of the infant carrier
module can be adjusted to 3
positions.
4
!
Position 1- Position for car, hand or
stroller transportation.
Position 2- Rocking position.
Position 3- Baby chair position.
To adjust the handle, squeeze the
handle buttons on both sides to
-1
release it , and then rotate the
5
handle until it clicks into any of the 3
-2
positions.
5
Installation with base
see images -
6 13
1. Unfold the load leg from storage
compartment.
6
7
4
1
2
3
5
2
1
6
2. After placing the base on the vehicle seat, extend the load leg to
floor , When the load leg indicator shows green means it is
7
installed correctly, red means it is installed incorrectly.
!
The load leg has multiple positions. When the load leg indicator
shows red this means the load leg is in the wrong position.
!
Make sure the load leg is in full contact with the vehicle floor pan.
!
Squeeze the load leg releasing button, then shorten the load leg
upwards.
!
Always make sure the support load leg has direct contact with the
floor and is in locked position even when the child is not in it.
7
3. The completely assembled base is
shown as
8
!
The load leg must be installed
correctly with green indicator.
-3
7
3
1
2
8
8