Joie i-Juva Manuel D'instructions page 10

1. Place the infant carrier module onto
the vehicle seat where you wish to
put it. Pull the vehicle safety belt out
and lock it into the vehicle buckle,
sliding the vehicle lap belt into the
side guides of the infant carrier
module.
28
!
The infant carrier module can not be
used if the vehicle safety belt buckle
(female buckle end) is too long to
anchor the infant carrier module
-1
securely.
28
2. Slide diagonal belt into the rear
guide.
29
3. Pull the vehicle shoulder belt to
fasten the infant carrier module
tightly and securely.
30
17
28
! !
! !
1
29
! !
30
4. Level line on infant carrier module
must be level to the ground when the
infant carrier module is installed.
!
Tension the vehicle safety belt as
much as possible, checking that it is
not loose or twisted.
!
After installing the infant carrier
module, always check that the
vehicle belts are routed correctly and
securely fastened into the vehicle
buckle.
32
31
31
32
18