Before Requesting Service - Panasonic NN-SE284S Mode D'emploi

IP4871_3BL70CP_Eng_27_140603:IP3677_38Q04CP_00_110608.qxd 2014-6-3 9:44 Page 30
These things are normal:
The oven causes interference
with my TV.
Steam accumulates on the oven
door and warm air comes from
the oven vents.
PRObLEm
Oven will not turn on.
Oven will not start cooking.
the word "DeMO MODe"
appears on the Display
Window.
the Glass tray wobbles.
When the oven is operating,
there is noise coming from the
glass tray.
the word "LOCK" appears in
the Display Window.
the oven stops cooking and
"SeRVICe" appears in the
Display Window.

before Requesting Service

Some radio, TV, Wi-Fi, cordless telephone, baby monitor, blue tooth or other wireless
equipment interference might occur when you cook with the microwave oven. This
interference is similar to the interference caused by small appliances such as mixers,
vacuums, blow dryers, etc. It does not indicate a problem with your oven.
During cooking, steam and warm air are given off from the food. Most of the steam and
warm air are removed from the oven by the air which circulates in the oven cavity.
However, some steam will condense on cooler surfaces such as the oven door. This is
normal. After use, the oven should be wiped dry (see page 27).
POSSIbLE CAUSE
the oven is not plugged in securely.
Circuit breaker or fuse is tripped or
blown.
there is a problem with the outlet.
the door is not closed completely.
Start Key was not touched after
programming.
another program is already entered
into the oven.
the program is not correct.
Stop/Reset Key has been touched
accidentally.
Demo mode was selected "On".
the Glass tray is not positioned
properly on the Roller Ring or there
is food under the Roller Ring.
the Roller Ring and oven bottom
are dirty.
the ChILD LOCK was activated.
this display indicates a problem
with the microwave generation
system.
30
REmEDy
Remove plug from outlet, wait 10 seconds and
re-insert.
Reset circuit breaker or replace fuse.
Plug another appliance into the outlet to check if
it is working.
Close the oven door securely.
touch Start Key.
touch Stop/Reset Key to cancel the previous
program and enter new program.
Program again according to the Operating
Instructions.
Program oven again.
Deactivate mode by tapping Power Level
key once Start Key 4 times and Stop/Reset Key
4 times.
take out Glass tray and Roller Ring. Wipe with
a damp cloth and reset Roller Ring and Glass
tray properly.
Clean these parts according to Care and
Cleaning of your microwave Oven
(see page 27).
Deactivate LOCK by tapping Stop/Reset key
3 times (see page 11).
Please contact an authorised Service Center
(see page 31).