Setting The Clock; Setting Light; Setting Turntable On/Off; Setting Fan - Panasonic NN-SE284S Mode D'emploi

IP4871_3BL70CP_Eng_27_140603:IP3677_38Q04CP_00_110608.qxd 2014-6-3 9:43 Page 12

Setting the Clock

Example: To set 11:25 a.m. or p.m.
1.
2.
Swipe
3.
NOTES:
1. to reset the clock, repeat steps 1-3.
2. the clock will retain the time of day as long as the oven is
plugged in and electricity is supplied.
3. Clock is a 12 hour display.
4. Oven will not operate while colon is flashing.

Setting Light

Setting Turntable On/Off

NOTE:
When "turntable OFF" is selected, it will automatically return
to "On" again after the heating cycle is completed.
Do not operate the oven "turntable Off" when cooking foods
on Popcorn / Inverter turbo Defrost / Sensor Reheat / Sensor
Cook.
Sometimes the glass tray can become too hot to touch. Be
careful when touching the glass tray during and after cooking.
• tap Time/Clock twice.
Colon flashes.
• Set time of day by tapping "+"/"-" or
swipe the slider bar.
time appears in the display window;
colon continues flashing.
• touch Timer/Clock once.
Colon stops flashing; time of day is
entered.
this feature allows you to control the
brightness of Cooktop Light.
tap Light key once for hi-Warm light,
twice for the hi-Cool light, three times
for Low light, and tap again to turn the
light off.
For best cooking results, leave the
turntable on. It can be turned off for
large dishes.
touch "turntable On/Off" key to turn
the turntable on or off.
When you turn it off, will appear in
the display window.

Setting fan

the Fan (Vent Fan) removes steam
and other vapors from the cooking sur-
face below the microwave oven. tap
Fan key once for low fan speed, twice
for high fan speed , 3 times for turbo
fan speed, 4 times for super fan speed,
and tap again to turn the fan off. When
you turn it on,
display window.
Note:
1. the "turbo" fan speed will run for a
few seconds even though the
"high/Low" fan setting is selected.
this is absolutely normal.
2. hold fan key for 2 seconds to turn off
the fan.
NOTE: Automatic fan
If the microwave oven is used for a long time or if cooking
equipment under the microwave oven is used simultaneously,
the temperature may get too hot around the microwave oven
and the vent hood fan will automatically turn on at the turbo
setting to cool the oven. When this occurs the display window
shows "vENTILATINg", and the fan cannot be manually
turned off. If subsequently another key is touched and "HOT"
appears in the display window, the microwave oven will not
operate, and you must wait until the microwave is cool and
"HOT" disappears from the display to re-program. the fan will
automatically turn off when the internal components are cool. It
may continue cooling for 30 minutes or longer.
When "COOLINg" appears in the display window
after either using the microwave oven for a long time or using
the cooking equipment under the microwave, "COOLInG" may
appear in the display window, and the cooling fan will run until
components inside are cool. the microwave oven will continue
to operate normally.

Setting Auto Off 1/3/5/10

after you have selected Fan On, you
can set the desired time that automati-
cally turns off the Fan. tap "auto Off
1/3/5/10" key to set fan time. the fol-
lowing is the set times for the number of
taps to the key:
one tap
two taps
three taps
four taps
five taps
NOTE: If auto Off is touched after auto Off time had been set,
you must reset the time.
12
will appear in the
1 min
3 min
5 min
10 min