Before Requesting Service - Panasonic Inverter NN-S255 Manuel

These things are normal:
The oven causes interference
with my TV.
Steam accumulates on the oven
door and warm air comes from
the oven vents.
PROBLEM
Oven will not turn on.
Oven will not start cooking.
The Glass Tray wobbles.
When the oven is operating,
there is noise coming from the
glass tray.
The word "Child" appears in
the Display Window.
The word "DEMO MODE"
appears on the Display
Window.
The oven stops cooking by
microwave and "H97" or
"H98" appears in the Display
Window.

Before Requesting Service

Some radio and TV interference might occur when you cook with the microwave oven.
This interference is similar to the interference caused by small appliances such as
mixers, vacuums, blow dryers, etc. It does not indicate a problem with your oven.
During cooking, steam and warm air are given off from the food. Most of the steam and
warm air are removed from the oven by the air which circulates in the oven cavity.
However, some steam will condense on cooler surfaces such as the oven door. This is
normal. After use, the oven should be wiped dry (see page 24).
POSSIBLE CAUSE
The oven is not plugged in securely.
Circuit breaker or fuse is tripped or
blown.
There is a problem with the outlet.
The door is not closed completely.
Start Pad was not pressed after
programming.
Another program is already entered
into the oven.
The program is not correct.
Stop/Reset Pad has been pressed
accidentally.
The Glass Tray is not positioned
properly on the Roller Ring or there
is food under the Roller Ring.
The Roller Ring and oven bottom
are dirty.
The CHILD LOCK was activated
by pressing Function pad and
selecting "CHILD LOCK ON".
Function Pad was pressed and
selected "DEMO MODE ON".
This display indicates a problem
with the microwave generation
system.
Remove plug from outlet, wait 10 seconds and
re-insert.
Reset circuit breaker or replace fuse.
Plug another appliance into the outlet to check if
it is working.
Close the oven door securely.
Press Start Pad.
Press Stop/Reset Pad to cancel the previous
program and enter new program.
Program again according to the Operating
Instructions.
Program oven again.
Take out Glass Tray and Roller Ring. Wipe with
a damp cloth and reset Roller Ring and Glass
Tray properly.
Clean these parts according to Care and
Cleaning of your Microwave Oven
(see page 24).
Deactivate LOCK by pressing Function pad,
touching number 5 and selecting "CHILD
LOCK OFF". (see page 10)
Deactivate mode by pressing function pad,
touching number 0 and selecting "DEMO OFF".
(see page 10)
Please contact an authorised Service Center
(see page 28).
27
REMEDY