Timer Feature (Kitchen Timer/Stand Time/Delay Start) - Panasonic NN-SE284S Mode D'emploi

IP4871_3BL70CP_Eng_27_140603:IP3677_38Q04CP_00_110608.qxd 2014-6-3 9:44 Page 21
this feature allows you to program the oven as a kitchen
timer. It can also be used to program a standing time after
cooking is completed and/or to program a delay start.
To Use as a Kitchen Timer:
Example: To count down 5 minutes.
1.
2.
Swipe
3.
To Set Stand Time:
Example: To cook at P6 power for 3 minutes, with stand
time of 5 minutes.
1.
tap 5 times
2.
Swipe
3.
4.
Swipe
5.
Timer feature
• touch Timer/Clock once.
• Set time by tapping "+"/"-" or swipe
the slider bar to 5 minutes.
• touch Start.
time will count down without oven
operating.
• enter the desired Power Level
(see page 13 for directions).
• Set cooking time, tapping "+"/"-" or
swipe the slider bar to 3 minutes.
• touch Timer/Clock once.
• Set stand time, tapping "+"/"-" or
swipe the slider bar to 5 minutes.
• touch Start.
Cooking will start. after cooking,
stand time will count down without
oven operating.
CAUTION:
If oven lamp is lit while using the timer feature, the oven is
incorrectly programmed. Stop oven immediately and
re-read instructions.
To Set Delay Start:
Example: To delay the start of cooking for 5 minutes, and
cook at P6 power for 3 minutes.
1.
• touch Timer/Clock once.
2.
• Set delay time by tapping "+"/"-" or
swipe the slider bar to 5 minutes.
Swipe
3.
• enter the desired Power Level
(see page 13 for directions).
tap 5 times
4.
• Set cooking time, tapping "+"/"-" or
swipe the slider bar to 3 minutes.
Swipe
5.
• touch Start.
Delay time will count down. then
cooking will start.
NOTE:
1. When each stage finishes, a two-beep signal sounds. at the
end of the program, the oven will beep five times.
2. If the oven door is opened during Stand time, Kitchen
timer or Delay time, the time on the display will continue to
count down.
3. Stand time and Delay start cannot be programmed before
any automatic function. this is to prevent the starting tem-
perature of food from rising before defrosting or cooking
begins. a change in starting temperature could cause inac-
curate results.
4. the maximum programmable time of Standing time,
Kitchen time or Delay time is up to 90 minutes.
21