Disposal Of Materials; Disposal Of Consumables; Packaging; Appendix - Abicor Binzel ABICOOLER 1300 115 CSA Mode D'emploi

13 Appendix

12.1 Disposal of materials

This product is mainly made of metallic materials that can be melted in steel and iron works and are thus
almost infinitely recyclable. The plastic materials used are labeled in preparation for their sorting and
separation for later recycling.

12.2 Disposal of consumables

Oil, greases and cleaning agents must not contaminate the ground or enter the sewage system. These
substances must be stored, transported and disposed of in suitable containers. Contaminated cleaning tools
(brushes, rags, etc.) must also be disposed of in accordance with the information provided by the
consumables' manufacturer.
► Observe the relevant local regulations and disposal instructions in the safety data sheets specified by
the manufacturer of the consumables.

12.3 Packaging

ABICOR BINZEL has reduced the transport packaging to the necessary minimum. The ability to recycle
packaging materials is always considered during their selection.
13 Appendix

13.1 Connecting diagram for flow control

Fig. 6 Connecting diagram for flow control
Welding power source
Torch control switch on the
welding power source
EN - 22
Torch trigger
Connection housing
ABICOOLER 1300 115V CSA
Connection for flow control on
the front of the device
Flow control
(low cooling liquid volume opens the circuit)