Mail Slot; Import/Export Operation - JVC MC-8100LU Manuel D'instructions

6-2. Import/export operation

When loading/ejecting discs from any chosen tray by the mail slot without the control of the host computer, follow the proce-
dure shown below.
• During the import/export operation, the host computer commands which include the carrier operations cannnot be ex-
ecuted.
1.
In the normal display mode, press the MODE key.
(The menu display appears.)
2.
Press the SELECT key 7 times.
("8. IMPORT/EXPORT" appears.)
3.
Press the ENTER key.
(Select "8. IMPORT/EXPORT".)
4.
Press and hold the SELECT key for more than 5 sec-
onds.
(Wait until the display starts to blink.)
5.
Release the SELECT key when the input start tray
message is prompted.
6.
Enter the start tray number(001-100) using the 10-key
pad.
•If the number is wrong, input a new 3-digit tray No.(ex.
001) again.
7.
Press the ENTER key.
8.
Enter the end tray number(001-100) using the 10-key
pad.
•If you wish to use the import/export operation for sin-
gle disc, either enter the same end tray number as the
start tray number or press the ENTER key without
entering any number.
9.
Press the ENTER key.
•You can cancel the following operations by pressing
and holding the ENTER key for 5 seconds during the
import/export operation. If the mail slot opens after
cancelling the operation, press the LOAD/EJECT
key.(The tray in operation will be returned to the maga-
zine; then the import/export operation will be com-
pleted.)
1 . N O R M A L D I S P L A Y
2 . E R R O R D I S P L A Y
8 . I M P O R T / E X P O R T
9 . D R I V E D I S P L A Y
P U S H S E L . K E Y
I M P O R T / E X P O R T
P U S H S E L . K E Y
I M P O R T / E X P O R T
I N P U T S T A R T
T R A Y N o . : – – –
I N P U T S T A R T
T R A Y N o . :
I N P U T E N D
T R A Y N o . : – – –
I N P U T E N D
T R A Y N o . :
I M P O R T / E X P O R T
T R A Y N o . : 0 1 5

Mail Slot

F O R
F O R
0 1 5
0 2 4
E19