Door Opening/Closing - JVC MC-8100LU Manuel D'instructions

5. DOOR OPENING/CLOSING

Once the transport locks have been opened and the power has been turned on for the first time, the door is locked by the
internal safety locking system in addition to locking by the door opening/closing key, so that the door cannot be opened by the
key alone.
To open the door under these conditions, keep the power on, or turn it on if it had been off, and then perform the following
operations before using the door opening/closing key.
Door Opening
1.
In the normal display mode, press the MODE key.
(The menu display appears.)
2.
Press the SELECT key 4 times.
("5. DOOR OPEN MODE" appears.)
3.
Press the ENTER key.
(Select "5. DOOR OPEN MODE".)
4.
Press and hold the SELECT key for more than 5 sec-
onds.
(Wait until the display starts to blink.)
5.
Release the SELECT key when the execution display
appears.
*When installing/removing drive units, turn off the power
after the completion display (THE DOOR CAN BE
OPENED) appears.
6.
Inser t the door key in the cylinder and turn it
counterclockwise to release the lock and open the door.
Unlocked
Locked
Door Closing
1.
Close the door and lock it by turning the door key clock-
wise.
2.
Press the ENTER key when the display on the right
appears.
• The normal display returns after initialization.
• You cannot perform disc transport operations when the above door opening mode is being executed or the door is open.
Door opening/closing
key cylinder
1 . N O R M A L
2 . E R R O R D I S P L A Y
5 . D O O R O P E N
6 . I D N o . S E T
P U S H S E L E C T
T O O P E N T H E
P U S H S E L E C T
T O O P E N T H E
E X E C U T I N G
O P E N
T H E D O O R
C A N B E
The door is open.
D O O R O R P A N E L
I S O P E N E D
The door is closed.
P U S H E N T E R
T O R E S U M E
D I S P L A Y
M O D E
M O D E
K E Y
D O O R
K E Y
D O O R
D O O R
P R O C E S S
O P E N E D
K E Y
E17