Control Surface Centering; Propeller Installation - Horizon Hobby E-Flite Pawnee Brave Night Flyer Manuel D'utilisation

EN
Model Assembly Continued
Clevis Installation
• Pull the tube from the clevis to the linkage.
• Carefully spread the clevis, then insert the clevis pin into the desired hole in
the control horn.
• Move the tube to hold the clevis on the control horn.
al

Control Surface Centering

After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the length of
the linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and
sub-trims to 0, then adjust the clevises to center the control surfaces.

Propeller Installation

1. Install the collet (A), backplate (B), spinner backplate (C) and propeller (D)
onto the motor shaft (E).
2. Secure the propeller into place using the washer (F) and spinner nut (G).
IMPORTANT: Ensure that the propeller size numbers (10 x 8) are facing
towards the rear of the aircraft.
3. Align the spinner and press it into place. It will snap into place with a little
pressure.
When needed, remove the spinner by putting side force on the tip until it pops
loose.
8
1.
2.
3.
D C B
G F
H
4.
5.
6.
A E
10 X 8