Control Response Test Bnf; Propeller Installation; Center Of Gravity (Cg) - Horizon Hobby E-FLITE Turbo Timber Evolution 1.5m Manuel D'utilisation

AS3X

Control Response Test BNF

®
WARNING: Do not perform any testing or maintenance with the propeller
installed on the aircraft. Serious injury or property damage could result
from the motor starting inadvertently.
This test ensures that the AS3X control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before performing
this test.
1. Raise the throttle just above 25%, then lower the throttle to activate
AS3X technology.
WARNING: Keep all body parts, hair and loose clothing away from
spinning motor, as these items could become entangled.
2. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond
as shown, do not fly the aircraft. Refer to the receiver manual for more
information.
Once the AS3X system is active, control surfaces may move rapidly. This is normal.
AS3X remains active until the battery is disconnected.

Propeller Installation

WARNING: Do not install the propeller until the aircraft has been
completely assembled, all the systems have been checked thoroughly and
you are located at a suitable flying site.
WARNING: Never install a cracked, nicked or otherwise damaged
propeller or spinner.
NOTICE: If the propeller is not balanced, the aircraft may vibrate, causing the
stabilization system to not operate correctly and/or decrease the life of the servos.
1. Install the prop adapter and collet.
2. Install the propeller, ensuring the embossed size numbers are facing forward.
3. Install the nut. Do not overtighten the prop nut as damage to the propeller or
threads may result.
4. Install the spinner and secure it in place with the included M3 x 8mm machine
screw. Ensure the propeller blades are centered in the spinner cutouts. Allowing
the spinner to contact the propeller may cause damage to the propeller and
may lead to failure of the propeller.

Center of Gravity (CG)

The CG location is measured from the leading edge of the wing at the root.
(without slats installed) 60mm +/-5mm back from the leading edge
NOTICE: Install the battery and hatch but do not arm the ESC while checking the
CG. Personal injury may result.
Aircraft movement
EN
AS3X Reaction
60 +/-5mm
back from leading edge
of wing at the fuselage.
13