Grinding Wheel - PRO-POINT 8354649 Mode D'emploi

V 3.05
INSTALLATION OF THE SIDE HANDLE
Attach the side handle firmly into the desired position. It can be
installed in two locations on the machine's housing - the left or
right side, depending on your preference.

GRINDING WHEEL

WARNING! Always be sure that the tool is switched off,
disconnected and has stopped moving before attempting to
perform any adjustments.
1. Place the backing washer over the spindle, making sure the
fit is tight.
2. Place the grinding or cutting wheel on the top of the backing
washer ensuring the bore fits into the step of the flange.
3. Mount the concave recess side of the locking nut over
the spindle.
3.1 Position the protruding part of the outer flange towards
the disc if you are mounting a grinding wheel.
3.2 Position the protruding part of the outer flange away
from the disc if mounting a cut-off disc.
4. Press the spindle lock and ensure there is no movement in
the spindle. Then while the spindle lock is depressed tighten
the locking nut in a clockwise direction using the pin spanner.
5. Allow the angle grinder to run idle for at least a minute with
the grinding or cutting disc correctly assembled.
5.1 A vibrating wheel should immediately be reinstalled and
tested. If the wheel continues to vibrate, replace with a
new one.
OPERATION
1. Disconnect grinder from the air source.
2. Fit the appropriate disc to the grinder.
3. Connect the grinder to the air source and press the trigger.
Allow the grinder to run for a minute with no load before use.
4. For the best work results hold the grinder at a 10 to 15° angle
to the workpiece.
10
All manuals and user guides at all-guides.com
5 in. Composite Air Angle Grinder
For technical questions call 1-800-665-8685
8354649