Publicité
Les langues disponibles
Les langues disponibles
6.6 Preparatory work before
installation
6.6.1 Opening the base of the product
To avoid scratching the product with the hexagonal
wrench, align the body of the product with the screw
to remove.
Unscrew the three screws at the bottom of the
product (Fig. 9, page 15).
Fig. 9
MNVCEVO_1947_EN
6.6.2 Mounting the bracket
Take special care when attaching and
fastening down the apparatus. If the
equipment must be fastened to a concrete
surface, plugs must be used with a
minimum traction force of 300dN each. For
a metal surface use screws with a diameter
of at least 8mm and of an appropriate
length. The fastening system must be
capable of supporting at least 4 times the
weight of the entire equipment (pan & tilt,
lens, camera, supports and adapters).
The device should be assembled vertically.
Any other position could impair the
performance of the appliance.
Various types of support are available (10 Accessories
and Supports, page 24).
Choose the adequate support for installation you
want to implement (6.5 Installation mode, page 11).
Install the support following the instructions outlined
in the relevant manual.
15
Publicité
