Configuration With Pc Software - Reely 450 ARF Notice D'emploi

h) Configuration of the PC software
To fly the quadrotor helicopter using your own settings, you may connect the electronics system of the quadrotor
helicopter to a PC via an interface cable (serial TTL on USB).
A PC configuration set is optionally available for this. This contains a connection cable, a detailed description and the
software on CD. This kit may be used with Microsoft® Windows XP®*, Windows Vista®* and Windows 7®* (* Microsoft,
Windows XP, Windows Vista and Windows 7 are registered trademarks of the Microsoft Cooperation in the USA and
other countries).
As it is not necessary to carry out configuration using a PC for normal flight operation, this is only mentioned here as
a side note. More information about the configuration can be found in the software operating instructions.
When jumper "R1" is set, the quadrotor helicopter is in PC configuration mode (PC mode) and cannot be flown.
Remove this jumper for normal flight operation!
On the control board, below the LEDs a micro push button is mounted which can be used to reset the
control electronics. For this, press the micro push button with the battery connected for around 1 second.
Then the electronics will restart and start in the status set according to each jumper. The effect is the same
as for "unplug flight battery".
The micro push button (1) and the interface (2) are
on the control board (3). For photo-technical rea-
sons, you will find the dismantled circuit board of
the control board in picture 15.
Figure 15
57