Reely 450 ARF Notice D'emploi page 53

b) Familiarisation of the channels from the transmitter (general)
Before you begin with the familiarisation, unplug
the battery, if connected, from the quadrotor
helicopter. Also disconnect the connection cable to
the PC, if connected, from the quadrotor helicopter.
Use a jumper (see picture 1, position 8) for the RC
configuration setting "R2" for "remote setting" (5).
You will find the plug connectors for the jumper in
the right upper area on the reverse of the control
board (the main control board in the middle) of the
quadrotor helicopter.
On one side of the board (1), both of the LEDs (2)
indicate particular operating statuses. Opposite on
the other side of the board (3), the plug connectors
"S1, S2, R1, R2" (4) for the jumpers are to be seen.
To operate the quadrotor helicopter in "remote setting" mode, affix the jumper "R2" (5) as shown in picture 10. This
setting is independent from other affixed jumpers.
Important!
Before switching the transmitter on, please set the throttle stick to "motor off" and all trim levers/ trim sliding
controller of the pilot stick to the neutral position. Otherwise, the quadrotor helicopter may not recognise
the transmitter after the battery is connected.
Now switch on the transmitter, pull the transmitter's retractable aerial completely out. Please ensure that all levers and
trims of the transmitter are in neutral position. The examples given show the procedure using a remote control in mode
2. Should you prefer to use another mode, the used axes may differ (see chapter "possible control modes")!
Please also ensure that the sliding controller for the trim is set to neutral position! Otherwise correct recognition of the
channels will not be possible!
Please also ensure that lever movements are made
in the right direction, otherwise the signals will be
memorised in reverse! Computer remote controls
should always be operated without mixer!
Move the gas lever (see picture 11) backwards to
the neutral position (motor off), all other control
devices should be set to neutral.
Do you want to try out "pitch reverse" (during "mo-
tor off" the pilot stick for gas is pulled away from
the body), then bring the gas lever forwards into
the max. position before you connect the battery.
Figure 10
Figure 11
53