PRO-POINT 9081548 Mode D'emploi page 12

9081548
13. Thread the lower round nut (#18) onto the ram from beneath and
tighten to secure the ram to the cylinder base plate.
14. Connect the short hydraulic hose (#32) to the ram cylinder's
connection nut. Connect the other end to the 90° connection nut
(#27) on the three-way valve block.
15. Connect the air pump's hose to the outlet port of the foot air valve.
• Follow the instructions for wrapping the threads with sealant
tape in Install an Air Coupler Plug.
16. Push each bed frame pin (#36) through the matching set of holes
on the left and right side of the frame. The bed frame will rest on
these, so ensure they are level with each other. Secure the pins
with the included clips (#37).
17. Position the bed frame so the beams are outside of the leg
assemblies. Lower until the bed frame is resting on the pins.
18. Install the rollers. Slide an M10 washer (#A7) onto an M10x35 bolt
(#A11), then a roller bushing (#A12) and a short bushing (#A13).
Screw the bolt into one of the inner bolt holes on the bed frame's
face. Repeat for the other 3 rollers.
19. Place an M10 washer (#A7) onto an M10x50 bolt (#A6) and insert
it in the top bolt hole of the left adjusting base. Place another M10
washer, then a bushing onto the protruding bolt. Prepare a second
bolt in the same manner.
20. Position the left adjusting base (#A8) with the angled side to the
outside and the knob (#A10) on the inside. Screw the bolt into
the upper outer bolt hole on the bed frame's left side. Screw the
second bolt into the lower bolt hole.
21. Repeat steps 18 and 19 with the right adjusting base.
22. Place the screen handle (#A1) on the screen and align the bolt
holes. Insert an M6x20 bolt (#A4) through each bolt hole. Secure
each with an M6 washer (#A2) and M6 nut (#A3).
23. Slide the screen into place between the rollers until the height is
appropriate to protect the user during the task. Tighten the two
adjusting base knobs to hold the screen in place.
24. Insert the handle (#11) into the pump receiver for manual
operation.
Assistance available at www.princessauto.com or 1-800-665-8685
PNEUMATIC/HYDRAULIC SHOP PRESS V1.0
Page 12