PRO-POINT 9081548 Mode D'emploi page 9

V1.0
to never exceed the maximum pressure rating of the tool (see
Specifications). Exceeding the maximum PSI rating can create a
bursting hazard, causing injury and property damage.
a. The tool does not regulate the pressure level. The power
output is in direct proportion to the air pressure available. An
external air pressure regulator is required to safely use this
tool.
5. Never use oxygen, combustible gas or any other bottled gas as
a power source. Any power source other than an air compressor
could cause an explosion and serious personal injury.
6. Turn OFF the valve and discharge any remaining air pressure after
each use or before adjusting the tool.
7. Do not leave the air tool unattended with its compressed air supply
on. Turn off the compressed air supply and bleed the air tool of any
remaining compressed air before leaving the air tool unattended.
8. Serious injury may occur from loose debris being propelled at
high speeds from the compressed air stream. Always wear OSHA
approved safety glasses to protect the eyes during operation of the
air compressor.
9. Always turn off the air compressor and drain tank pressure
completely before attempting maintenance or attaching air tools.
Release pressure slowly from the system.
10. Do not cover the air vents.
AIR HOSE PRECAUTIONS
1. Inspect the tool's air hose for cracks, fraying or other faults before
each use. Discontinue use if the air hose is damaged or hissing
is heard from the air hose or couplers. Replace the defective air
hose.
2. Do not allow people, mobile equipment or vehicles to pass over the
unprotected air hose. Position the air hose away from high traffic
areas, in a reinforced conduit or place planks on both sides of the
air hose to create a protective trench.
3. Prevent damage to the air hose by observing the following:
a. Keep the air hose behind the tool and out of the tool's work
path.
Page 9
PNEUMATIC/HYDRAULIC SHOP PRESS
Assistance available at www.princessauto.com or 1-800-665-8685
9081548