Bleeding The Hydraulic System - PRO-POINT 9081548 Mode D'emploi

9081548
3. Remove the oil fill plug.
4. Lay the on its side and drain the oil into a suitable container.
Dispose of used hydraulic oil in accordance with local by-laws.
5. Stand the on its base and wipe off any excess oil.
6. Reinstall the hydraulic onto the press.
7. Follow the instructions for Refill the.
REFILL THE HYDRAULIC JACK PUMP
The pump may become less efficient when the hydraulic oil level is too
low or contaminated by metal particulate through normal wear-and-tear.
1. Retract the ram and remove the oil filler plug.
2. Check and maintain the ram oil level.
• Check the oil level with the oil dip stick. Use a long plastic
cable tie as a substitute if the unit does not have a dipstick.
3. Fill the cylinder with a high quality hydraulic jack oil, up to the oil
plug opening.
a. Place a funnel into the oil fill neck. The funnel opening should
be wide enough to prevent the oil from collecting in the
funnel's cone.
b. Pour oil into the funnel. Allow the oil to settle for one minute
and recheck the level. Repeat until the desired level is
reached.
4. Follow the steps in Bleeding the Hydraulic System.
5. Insert the oil filler plug and hand tighten.
6. Wipe up any spilled oil. Dispose of oil soaked rags in a proper
hazardous waste container.

BLEEDING THE HYDRAULIC SYSTEM

Bleed excess air from the hydraulic system as follows:
1. Open the release valve by turning it counterclockwise.
2. Remove the oil filler screw and fill the hydraulic jack pump with
hydraulic fluid.
3. Wait 5 minutes for trapped air to rise to the surface.
Assistance available at www.princessauto.com or 1-800-665-8685
PNEUMATIC/HYDRAULIC SHOP PRESS V1.0
Page 16